The forum is temporarily in read-only mode. You can read every thread, but new posts and registrations are paused for now. Leave a message on the Nostalgia wall · More information

With iontophoresis, is a higher amperage better?

Started by BBoyLayZ · Jul 7, 2015 · 7 replies

#1 Report
I ask because sometimes I can do 40V at the same pulse width and the Hidrex shows 2mA and other times it shows 22mA. It seems to vary quite a bit, and I realize that's because my own body resistance can change pretty quickly. But is it the voltage that matters or the current? If during a session, I'm noticing the mA is staying low, should I raise the voltage to try to get that mA back up? Are sessions where I'm at 40V and 2 mA not as good as 40V and 22mA?
#2 Report
I also wondered the same. I hope someone can shed some light on this.


Sent from my iPhone using Tapatalk
#3 Report
22mA sounds about right. No clue on the voltage.
#4 Report
I've found that lower amps works best for me. For hands typically around 12. Why? Not sure but that is what works best. I have read others having better success with lower versus higher.
#5 Report
interesting
#6 Report
I find that higher amperage is better, yes. If you can take it. Higher amps = more discomfort, naturally.

Over my first year I slowly built up and settled on 28mA. At that level I only really have to do it once every 10 days or so.
#7 Report
I agree with higher amp being better. What worked for me is starting at 14.5mA. I think you should feel a continuous tingle bordering on discomfort.
#8 Report
With pulsed current you barely feel any tingling and discomfort becomes a thing of the past.

‹ Back to Hyperhidrosis Forum